Rio Fuse Specifications download pdf (Page 2)

GFCI

ONLY

Drip Loop

Controller

UL Listed

Transformer

Mini Sun Moon Light

(Optional part)

1 1

11 12 13 14

3 6

YES

11 12

the screen will now read 15 and the blue/second LED will be lit. If set on the LEFT or

RIGHT setting, the screen, will not be lit and pump will run continually.

13. Press the SET button until the desired time parameter is set. (a) Blue LED is

seconds. (b) Yellow LED is minutes

14. Once the desired time is set. Press the ENTER button.

15. To change time, press the SET button to desired set time and then press the ENTER

button.

16. When feeding, press the desired feeding time 8 or 16 minutes.

Note: Polario™ pumps are equipped with an automatic safety SHUT-OFF.

If the pump is on and is removed from water, it will automatically shut off. To reset, secure the pump

back on the magnet mount, then turn controller OFF then ON to reset.

MAINTENANCE:

It is the utmost importance to clean and maintain the pump monthly. Remove the Large intake strainers

and the endcaps to access the propeller. Remove the propeller which should slide off the motor easily.

Now reinstall and verify that the propeller rotates easily around the motor. If the propeller binds or there

is too much drag created: the motor, propeller and ceramic shaft need to be cleaned well. These high

speed motors attract calcium build up, let the pump soak in a water/vinegar solution for a minimum of

1 hour. (3 parts water to 1 part vinegar) Then clean well with a small brush. If the pump has not been

maintained on a regular basis or if high amount of calcium is added this process may be needed to be

repeated. If there is any noticeable damage to the propeller replace immediately.

Verify the intake strainers are free and clean of all debris

TROUBLE SHOOTING

Controller will not power up and/or pump will not turn on: It is imperative to keep the pump clean and well

maintained to ensure the pump is in good working order and the impeller and strainer clean at all times,

failure to do so will cause the 15 ML & 22 ML controller to shut down until the problem or problems are

rectified. At that time the unit may just go to default setting where as the controller is plugged in and the

green transformer light will be on however the controller will not power up or may power up for just a

few seconds then shut down. In some instances the controller’s fuse has blown in addition to going to

default setting. Replace fuse with a 22ML 3.5a/250v and 15ML 3.5a/250v slow blow fuse.

SOLUTION:

1. Check all intake strainers verifying that they are free of all debris.

2. Remove the Large intake strainers and the endcaps to access the propeller. Verify that there is not

anything blocking the propellers rotation.

3. Remove the Large intake strainers and the endcaps to access the propeller. Remove the propeller

it should slide off the motor easily. Now reinstall and verify that the propeller rotates easily around

the motor. If the propeller binds or there is too much drag created: the motor, propeller and ceramic

shaft need to be cleaned well. These high speed motors attract calcium build up, let the pump soak

in a water/vinegar solution for a minimum of 1 hour. (3 parts water to 1 part vinegar) Then clean

well with a small brush. If the pump has not been maintained on a regular basis or if high amount of

calcium is added this process may be needed to be repeated. If there is any noticeable damage to

the propeller replace.

15ML & 22ML

FEATURE

TURBINE DUAL ACTION

PROGRAMMABLE AQUA PUMP

• Energy efficient, high flow low voltage water pump

• Bi-directional outputs to simulate natural wave and

current actions of the ocean

• Variable time and output settings

• Flow rates up to 5,500GPH/22,000LPH

(on selected models)

• Single or dual outputs

• Preset feeding settings at 8 and 16 min.

• Magnet mount Included to secure pump

• Pre-programmed in all settings to gradually

Increase flow

• In “Auto” mode, pump initially alternates 15 sec.,

left and right

• The alternating water currents can be set to switch

every 15 sec. to 30 min.

• Mini sun moon light adapter included

• 16 volt UL listed transformer included

PART LIST

1. Couplers

2. Propeller

3. Large strainers

4. Main pump housing

5. Endcaps

6. Water diverters

7. Controller

8. Magnet Mount

9. Pump extension

10. O-Ring

11. Power supply connection

12. Pump connection

13. Fuse

14. Mini sun moon light adapter

15. UL listed transformer

16. Transformer power

supply cord

REPLACEMENT PARTS

Part Number Description

2 Polario

15ML Propeller

2 Polario

22ML Propeller

8 Polario

15ML MM300 Magnet Mount

8 Polario

22ML MM500 Magnet Mount

10 Polario

O-Ring

15 Polario

15ML UL Listed Transformer

15 Polario

22ML UL Listed Transformer

DIRECTIONS FOR INSTALLING

1. Select the mode on the controller in which the pump will

operate. There are three options: (a) “Auto” or alternating

discharge from left to right. (b) Left. (c) Right.

2. Choose a location for the pump.

3. Attach pump extension to the pump.

4. Install magnet mount: (a) Read all warnings! Handle this

product with care, failure to do so will cause injury and/or

damage to your aquarium. (b) Remove from box.

holder. (d) Separate the magnet holders by twisting units

apart. (e) Place the magnet in the desired location in the

aquarium.The magnet must be flat on the glass.

f. Place the outer magnet flat on the glass and slide it to

the inner magnet until they engage.

5. Attach the pump to the magnet mount.

6. Mount and secure the controller above and away from the

aquarium in an area that is dry and will stay dry.

7. Mount and secure the transformer in an area that is dry

and that will stay dry.

8. Plug the transformer into the controller.

9. Plug the pump into the controller.

10. Set the flow rate. It is recommended to set the flow at low

flow rate then adjust accordingly.

11. While the unit is OFF, plug the transformer into a GFCI

electrical receptacle.

12. Turn the controller ON. If the controller is set on AUTO

SPECIFICATIONS

Item # Watt

Pump Size

L x Dia. (Approx.)

Flow Rate (Approx.)

Aquarium Size

(Approx.)

Output O.D. Transformer Fuse Glass Thickness

UPC #

0006760

LPH GPH

4ML 7w

1.9 x 2 in

(4.8 x 5 cm)

2300-4000 600-1000

10-20 Gal.

(35-80 Ltr.)

2 in (50 mm)

1.6 amp

fast blow fuse

0.27 in

(7 mm)

1024 2

7ML 23w

2.1 x 2.4 in

(5.4 x 6 cm)

5000-7000 1300-1800

30-50 Gal.

(115-190 Ltr.)

2.4 in (60 mm)

2.5 amp

fast blow fuse

0.7 in

(18 mm)

1025 9

10ML 25w 6000-10000 1500-2600

40-100 Gal.

(150-380 Ltr.)

1026 6

15ML 30w

9.5 x 3in

(24 x 7.7 cm)

12000-15000 3000-3500

50-150 Gal.

(190-570 Ltr.)

2.55 in (65 mm) 16v

3.5 amp

slow blow fuse

0.5 in

(12 mm)

1015 0

22ML 50w 18000-22000 4500-5500

90-250 Gal.

(340-950 Ltr.)

3.5 amp

slow blow fuse

0.75 in

(20 mm)

1016 7

LIMITED WARRANTY

T.A.A.M. Inc.

warrants that the Polario™ is free from defects for a period of six months from the initial date

of purchase shown on the original cash register receipt. T.A.A.M. Inc.

disclaims all other warranties of merchantability

and/or fitness for a particular purpose. Although this limited warranty may give you specific rights, you may have other

rights that may vary from state to state. This warranty is void if the failure of the controller or any part, sealant or

component there of is due to (i) misuse, (ii) tampering, (iii) negligence, (iv) misapplication, (v) abuse, (vi) accident and/

or (vii) failure to properly (a) maintain, (b) clean, (c) keep free from water and moisture and/or use the controller with a

Ground Fault Circuit Interrupter (GFCI).

CONSUMER REMEDIES

T.A.A.M. Inc.

’s entire liability and your sole and exclusive remedy shall be either repair or replacement

of the Polario™ only if you return the defective unit directly to T.A.A.M. Inc.

with the original receipt in its original box

along with twenty dollars ($20.00) for shipping and handling. Do not send Polario™ by insured mail. You may send

your returns or replacements by UPS if requiring a signature upon arrival. Any replaced unit will be warranted for the

remaining time of the original warranty period. In no event shall any shipping charges be reimbursed. In no event will

T.A.A.M. Inc.

be liable for any consequential or incidental damages, including but not limited to, lost sea life, personal

injury, property damage, equipment damage, lost profits, lost wages, lost savings, lost income, etc., arising out of the

use of the Polario™. Some states do not allow for the limitation or exclusion of liability for incidental or consequential

damages, so the above exclusion may not apply to you.

RETURNS

Please contact our service center at (805) 383-3566 ext. 102 or fax (805) 383-3565 to arrange repair and/

or replacement. Please allow 4-6 weeks for all returns.

WARRANTY CARD

Please go to our website, to download Warranty Card.

http://www.riopump.net/Resources_folder/Warranty.html

Fill out this warranty card and mail it with PROOF OF PURCHASE

within 15 days of purchase

1 2

Comments to this Manuals

No comments

Rio Fuse Specifications Page 2

Comments to this Manuals

Related products and manuals for MP3/MP4 players Rio Fuse