Rio Fuse User Manual download pdf (Page 4)

- 4 -

Upgrade Installation Procedure

1. Change OPINT software parameters to reflect changes in hardware.

2. Install extra components into RIO box.

3. Fit the load cells if required.

4. Fit the speed sensor if required.

5. Fit the solenoid valve if required.

6. Fit the junction box to a suitable position on the wagon.

7. Connect the 7 core load cell/speed sensor cable into the junction box.

8. Connect the load cells to the junction box.

OPINT upgrade:

• To check the software version of the OPINT, connect it to a 12V power source. The

version will display for 3 seconds.

• If a speed sensor is to be fitted, version 2.16 should be used. Version 2.14 is suitable

for scales only.

OPINT software revision

GILTRAP

ENGINEERING LTD

RF FORAGE WAGON

Rev 2.16

• To enter set-up, press and together for 3 seconds or until the set-up screen

appears.

• If the above screen is not displayed, continue pressing until ‘Forage Wagon

Model’ shows.

ns for fitting upgrades to RF Series wagons.doc

Function

Parameter (Forage

Wagon Model)

Valve Fitted

Load Cells

Fitted

Speed Sensor

Fitted

Basic weighing of wagon

payload only

Scales No Yes No

Dispense feed per minute Weight Yes Yes No

Speed compensated floor

rate control

Distance Yes No Yes

Floor rate control only Standard Yes No No

Fully automatic dispensing

feed per metre

Distance Yes Yes Yes

• Press until Weight, Distance (if speed sensor is fitted) or Scales is displayed.

• Press to accept.

ENTER

TARE

ZERO

MODE

• Continue pressing to check the remaining parameters are correct.

MODE

• Press to exit the configuration screen and remove power from controller to

reboot.

ESCAPE

Instructio

1 2 3 4 5 6 7 8 9 ... 15 16

Comments to this Manuals

No comments

Rio Fuse User Manual Page 4

Comments to this Manuals

Related products and manuals for MP3/MP4 players Rio Fuse